Home-Portable Interactive Whiteboard
Portable Interactive Whiteboard
INTECH Portable Interactive Whiteboard is a fully featured interactive whiteboard system that transforms any standard whiteboard, flat surface (such as a wall) or projection screen into an interactive whiteboard.No battery is required for USB signal receiver and the unit can be mounted to the ceiling if a permanent solution is required. Working with the extendable pointer E-Pen(Electronic pen) or stylus E-pen, you and your students can explore internet websites, build interactive flipcharts and creat more opportunities for discussions and interaction in the classroom.
Specification
Signal Receiver
Movement DetectionTechnology Infrared
Active Area (max projection size) 150 inch diagonal
Active Area (horizontal angle) 33 +/- 2 degrees
Active Area (vertical angle) 0-30 degrees
Calibration Technology Infrared Positioning
Active Distance (from projection screen) 1.5 – 5 m
Connectivity Interface 1 xUSB Cable(connection distance up to 40 m)
Power Requirement 4.5 – 9 W (from USB port)
Power Consumption < 1.5 W
Weight 180 g
Dimension 11.5 x 7.5 x 2 (cm)
Extendable Pointer E-Pen (Electronic pen)
Movement Detection Technology LED Light
Control Buttons 2 buttons ( left and right click of a mouse)
Power Requirement 3 V CR123A x 1
Pen Body Dimension 15cm (length); 1.8cm (diameter)
Pen Body Weight 45g (with battery)
Pointer Extendable Length40 cm up to 78cm
Pointer Weight45g
Stylus E-Pen
Movement Detection Technology LED Light
Control Buttons 2 buttons ( left and right click of a mouse)
Power Requirement3 V CR123A x 1
Pen Body Dimension15cm (length); 18.5cm (diameter)
Weight 30g (with battery)
System Requirements
OS RequiredMicrosoft Windows 98/2000/xp,Vista
Processor Type Intel Pentium or above
RAM Size 128 MB
Min Hard Drive Space30 MB
Recommended Signal Reception Distance
Projection Size Distance between Receiver and Projection Surface
70 inch 2.6 m
100 inch 3.1 m
120 inch 3.6 m
150 inch 4.5 m
Application
Optional Installation
Accessories
The object of the Laser Pointer
FAQ
- Q: The light beam of signal is emanative, the shining distance becomes short and the strength of shining becomes poor.
A: The laser light is bad.
- Q: The receiver is connected with the PC, but the light is still not bright, and it can't be calibrated and written.
A: USB cable is bad. Change one new USB cable.
- Q: Can’t press the switch of signal receiver.
A: The switch of signal receiver is bad.
- Q: When calibrating, the cross-shaped can't disappear after clicking.
A: a. The laser pen covers up the signal resulting in the receiver can't receiving thesignal.
b. Between before and after calibrating, The environment of calibrating is different.
c. The receiver is shooting toward the projecting screen. Try your best not to shoot toward the Projecting screen.
- Q: The four cross-shaped skipping automatically without any clicking.
A: The light is too strong so as to interfere with the signal.
- Q: The pen point of laser pen is not bright so as not to receive the signal.
A: Don’t twist the white part on the pen point, or the LED wire may be twisted off.
- Q: The third cross-shaped can't skip result in not calibrating.
A: The light is too bright.
|
